Joined in 2023 
82 
63 About this deal
When the gpio pin goes high (3.3v) the transistor conducts and the high side of the reset is pulled down to ground, causing a reset. When the gpio is set low again, the PC restarts. The reason I specified 11 seconds in my (hopefully correct) python script was that I need to hold down my power button for 10 seconds to perform a hard reset, this would be the last options if for some reason the PC didn't respond. Of course, in my other scripts, such as the regular shutdown, I have set the time at 0.5 seconds which should simulate me just pressing the power button.
Once there, CHMOD all the files through your FTP program. Ensure they are all set to 777 otherwise your scripts cannot be ran from the web. Note the stuff about 'today' is because I based this on a similar script I use for hardware monitoring and the script stops at midnight and a new copy is started just after midnight. Also if the RPi has to be rebooted, the script starts after bootup using @boot in the crontab, and I don't want two copies running when the new copy starts just after midnight. Last, connect the relays to the motherboard power pins, run the command again and hope I don't kill anything! Type the following command to confirm the hibernation status and press Enter: powercfg /availablesleepstates A lot of new PC modders start with the same things: side-panel windows used to be a very common first mod but they’re pretty much standard issue now. One of the other most common initial mods is the power switch.
3 Comments
The junction of the two resistors will be at 2.5V which will be read as a ON or high by a gpio port set as an input. Biometric switches use fingerprint recognition to open or close a switch. While these are harder to find in a self-contained switch setup they are available. Now, loop one end of each wire through one of the terminals on the switch. Needle nose pliers can be used to make a nice, tight loop around the terminals. A simple circuit consisting of a general purpose npn transistor e.g. a 2N5088 and a couple of resistors works fine. I have two RPi's and each one can reset the other one using the reset pins. The same approach would apply to controlling the reset or power switches on a PC. I'm thinking I can detach the case buttons as I wont need these, and I can attach the motherboard headers to the GPIO pins on the Pi.
If you use sudo crontab -e you will access the root crontab and any scripts started from it will be run as root. I never thought of the pinging solution. Il have to work through that in my head and figure out the necessary commands to create a script (I can write that in batch in 30 seconds, but RPI doesn't run windows ) but it may be useful Totally Cool Switch Cover (Optional) - Might actually be helpful if you happen to have inquisitive young children, otherwise... You don't need to wait 11 seconds for a reset, although a power off usually requires that the circuit is held low for more than 4 seconds). Bear in mind that these switches will require power while the PC is turned off - an external power source will need to be included in the mod.Under the "The following states are available on this system" section, if Hibernate appears, then the feature is enabled. If it's not, continue with the steps below. PC power switch replacement is a good place to start your modding hobby. There are a lot of options to choose from, it can be a relatively easy process, and you can add a lot of character to a mod, whether it’s themed or not. The power switch you're referring to is for the power supply itself. This does not by itself turn on the computer; it merely allows the system to be powered on. JPWR1 (24 pins) is the main ATX power connector, while JPWR2 (8 pins) is the CPU power connector. These pins supply power to system components, and themselves do not turn the computer on.
Great Deal 
New Comment